Quark Carbon an BB30A -> Preload Adjuster durch Wellenscheibe ersetzen

[lighttom1]

Hallo,
bei meinem neuen SuperSix Evo habe ich meine Quark Carbon Kurbel montiert.
Lt. Anleitung soll ja der Preload Adjuster verwendet werden. Ich hasse diese teile, warum kann ich nicht statt dassen Spacer und eine Wellenscheibe benutzen. In der Anleitung der Alu Variante ist dies auch so berschrieben. Warum bei Carbon anders?

Gruß Thomas

 

[lighttom1]

Wem es Interessiert, ich habe eine Antwort vom Support erhalten:

The instructions between the two cranks are different because the physical dimensions of the products are different. In the aluminum's configuration that you sent the preload adjuster isn't needed because there is less length of exposed spindle on the aluminum version and the preload adjuster isn't needed to take up the existing slack. We recommend using the preload adjuster on the carbon cranks because it would be difficult to have the exact amount/length of spacers needed to eliminate play. The preload adjuster lets you fine tune that much more easily than having to have the correct spacers down to the tenth of a millimeter. I hope this has answeredd your question. If you have any other questions please let me know.